Model 940 Switching Power Supply / Speaker Console

Model 940 speaker console with internal switching power supply provides up to 25 amps current at 13.8 Vdc for powering HF transceivers and other Amateur Radio devices from an input of 115/230 VAC, 50/60 Hz. Internal high-quality 4 ohm 5 watt speaker is suitable for every possible communication need, from clean CW to well rounded AM receive audio.

More Information

Model 712 - USB soundcard digital mode adapter cable

The model 712 adapter cable is a soundcard USB device that allows direct connection of the AUX I/O, ACC 1, or AUX 1 jacks on the Omni VII, Orion/Orion II, Argonaut V and some Jupiter HF transceivers to an open USB port for digital mode use.

707 Regal desk microphone

The best sounding microphone Ten-Tec has offered yet for Amateur Radio, and possibly the best sounding one available from anyone today!

Order 707-T4 for Regal with 4 pin Ten-Tec connection cable.
Order 707-T8 for Regal with 8 pin Ten-Tec/Yaesu connection cable.
Order 707-RJ45 for Regal with RJ-45 modular Yaesu adapter ($25.95 additional).

More information

716 Table stand for 707 Regal desk microphone

Die-cast metal table stand for the Regal desk microphone. Threaded 6” tube for easy installation of the microphone.

Model 1213 rig-to-soundcard isolation and hookup kit

The model 1213 kit allows the rear panel AUX I/O jack on the Orion and Orion II transceivers, the rear panel ACC 1 jack on the Omni VII and Jupiter transceivers, or the front panel ACCESSORY jack on the Pegasus to be directly connected to a typical PC sound card for digital mode operation.

More Information

Orion or Orion II Auto Tuner Kit

The internal automatic antenna tuner can be added to any Orion or Orion II that does not have the autotuner already installed as a user-installable kit. The kit includes a completed circuit board, all necessary cables, and illustrated instructions. The AT566K is a no soldering required installation. Download the instruction manual.

Model 238C Tuner

New from Ten-Tec! Model 238C now features a large cross-needle SWR and peak reading power output meter. Model 238C uses our tried and true “L” match design used in the earlier 238/238A/238B models with a new cosmetic design, larger heavy duty tuning capacitor than the original and backlit cross-needle SWR and peak power output metering. Only $ 795.00!

715 RF Speech Processor for Ten-Tec rigs

Model 715 RF Speech Processor is a high performance true RF-type speech processor designed to operate with most modern HF Amateur Radio transceivers. Order 715-T4 for model 715 supplied with output cable for 4 pin Ten-Tec rigs like Jupiter, Omni-VI, Paragon. Order 715-T8 for model 715 supplied with output cable for 8 pin Ten-Tec rigs, Orion II and Omni-VII. The 715-T8 is also “plug and play” for 8 pin Yaesu transceivers.

More Information

5 pin DIN to RCA phono plug adapter cable

46176 5 pin DIN to RCA phono plug adapter cable. Used for interfacing the ACC DIN connector for PTT, audio in and audio out on the rear panel of the Omni-VII, Orion, Orion II, Jupiter and Argonaut V. Makes connecting accessory devices like a PC sound card to the rig easier than soldering your own DIN connector.

2 pin power cable

2 pin power cable as used for Orion, Orion II, Jupiter, Pegasus, Omni-VII, Delta II, Argonaut II, Argonaut V, Scout transceivers. 5 feet length, 14 AWG stranded copper with 2 pin AMP Mate-N-Lok connector on one end.

TEN-TEC The First 40 Years

TEN-TEC The First 40 Years. Author N.L. Williams, NR4RR, takes you through the first 40 years of the history of TEN-TEC. From the founding of the company in 1968 to the 2008 release of the Omni-VII, Williams’ book is a 132 page illustrated description of all that happened behind the scenes to make TEN-TEC what they are today.

USB to Serial Converter

Converts a USB port into a 9-pin male RS-232 serial port. The USB Serial Adapter is designed to make serial port expansion quick and simple.

Works with all Ten-Tec products with a RS-232 serial port.

702 Hand Microphone

702 Hand Microphone
Omni-directional, dynamic element, 500 ohm impedance, wired with an 8 pin connector for the Omni-VII and Orion II HF transceivers. Coiled connection cable. Also usable with 8 pin equipped Yaesu transceivers.

8-Pin deluxe desk microphone

Model 708A deluxe base microphone. TEN-TEC model 708A is an omni-directional dynamic microphones designed for use as a communications station microphone for Amateur Radio and other transmitting applications. The unit consists of a metal die-cast base (plastic bottom cover) with 3 position PTT switch with momentary TX, OFF, and LOCK positions, flexible metal gooseneck, dynamic microphone element and ball-type element housing. The element has tailored frequency response from 30 Hz to 12 kHz designed for excellent transmit audio in SSB, AM, and FM modes.

Orion II 300 Hz CW filter

Orion II 600 Hz CW filter

Orion II 1.8 kHz SSB filter

Centurion HF Amplifier

The model 422B CENTURION uses the classic pair of 3-500Z tubes. The RF deck and power supply are combined into a single, attractively styled, black desk top cabinet. The power output is rated at 1300 watts on SSB and CW and 650 watts using “key-down” modes. Drive required for full power SSB operation is 100 watts. The CENTURION operates on all bands (including WARC) from 1.8 to 21.5 MHz. 21.5 to 29.7 MHz is enabled with user installation of an expansion board, supplied at no charge upon proof of licensed authority.

Starting At $3195.00

Black External Speaker

The model 307B external communications speaker is designed for use with Ten-Tec radio receivers and transceivers. The 307B is a black cabinet as used for the Orion, Orion II, and Argonaut V HF transceivers, Omni-VII and the RX-350D receiver. The cabinet and speaker are suitable for every possible communcation need, from clean CW operation to well-rounded AM receive audio. The speaker response is 100 to 18000 Hz, 4 ohms impedance, 5 watts power. Speaker measures 4 inches diameter. Supplied with connection cable.

More Information

Cooling fan assembly

Model 310 cooling fan assembly is an external accessory cooling fan for HF transceivers. Hole-free attachment to transceiver rear heat sink via 4 allen screws.

Remote encoder/keypad

The 302R remote/encoder keypad allows armchair operation of the JUPITER, RX-350D, OMNI-VII, ORION, or ORION II. Black color is cosmetic match for current Ten-Tec HF transceivers. Direct frequency entry from keypad and control of some transceiver functions from three function buttons located above the tuning knob.

Desk stand for model 709/A

More Information

8-Pin straight microphone

Model 709A is an omni-directional dynamic microphones designed for use as a communications station microphone for Amateur Radio and other transmitting applications. The unit consists of a die-cast zinc shell with molded sliding PTT on/off switch, dynamic microphone element and detachable multi-wire connection cable. The element has tailored frequency response from 30 Hz to 12 kHz designed for excellent transmit audio in SSB, AM, and FM modes.

More Information

963 Power Supply

Model 963: Switching power supply for Ten-Tec HF transceivers. 115/230 VAC input, 25 amps continuous duty at 13.8 VDC output. Screw down terminals on rear for attachment of transceiver power cable. Size: HWD 3.75“x7“x9.25”. Weight, 4 pounds.